This hub was the brain child of one of our customers located in New York. Eric contacted us one day with an idea to make an eccentric fixed gear hub. The goal was to have a fixed gear hub that could be used with vertical drop outs without needing a chain tensioner. We were excited about the idea and began engineering the hub that we feel will transform the fixed gear market. The hub houses two sealed cartridge bearings, an aluminum axle, and stainless steel axle ends. The key is the location of the fixing bolts located in the axle ends. The bolts are offset 7.5mm from the center of the axle. Normally the fixing bolts are centered to the axle. Once in the frame the axle ends can rotate 180 degrees which gives 15mm of travel. Therefore, by rotating the axle ends you can attain proper chain tension. The eccentric ENO is a flip flop design allowing the rider to use a White Industries specific fixed gear on one side and a standard english threaded freewheel on the other. The hub can be ordered in 32h or 36h for frame spacings of 126mm, 130mm or 135mm.
© 2022 Bikeman. All Rights Reserved. Powered by Miva